Canon im2020, Setup Instructions

Page: 56 / 143

9219
– 3 –
4346-7741-02
6. Slightly raise the Right Door of the copier
and, at the same time, remove the Lower
Side Right Cover of the copier.
* Note the locking tab provided on the left side
of the cover.
4346U018AA
7. Remove the Ornamental Cover from the
lower part of the Right Door of the copier.
* Insert a flat-blade screwdriver under the lock-
ing tab of the Ornamental Cover and unlock
the tab.
• Cross-sectional view as viewed from the front
of copier
4346U036AA
Screwdriver
4346U038AB
8. Mount the Duplex Unit on the copier.
*
Fit the tabs at two places of the Duplex Unit
into the slits in the copier.
NOTES
• When mounting the Duplex Unit, use care
not to allow the Hookup Harness to be
wedged in mechanisms.
• Make a positive engagement of the rib of
the Duplex Unit with the round hole in the
Right Door of the copier. (If the rib is not
in place, there will be a clearance at the
portion indicated by the arrow in the illus-
tration on the left.)
4346U024AB
4346U025AA
9. Tighten the four fixing screws of the Duplex
Unit.
NOTE
Tighten the screws in the following order.
4346U026AA
(2)
(3)
(1)
(4)
10. Connect the Hookup Harness connector
located on the lower part of the Duplex Unit.
11. Place the Hookup Harness in the hook.
4346U027AA
12. Using the Screw furnished with the Duplex
Unit, secure the ground terminal in position.
4346U028AB
13. Reinstall the Lower Side Right Cover of the
copier (two screws).
NOTES
•
Make sure that the bottom of the Lower
Side Right Cover is on the underside of
the metal plate on the copier side.
•
Hook the tab of the Lower Side Right
Cover onto the frame of the copier.
4346U029AA