Canon im2020, Setup Instructions

Page: 47 / 143

9210
– 4 –
4344-7741-01
■ Checking for Skew Feed
4. Turn the screw on the left hinge as
necessary so that you feel resistance when
pulling out the strip of paper.
* If you feel a strong resistance, turn the screw
clockwise.
If you feel a feeble resistance, turn the screw
counterclockwise.
* As guidelines for the force to pull out the strip
of paper, it is equivalent to that exerted when
lifting the inner guide plate with a finger.
* After the Duplexing Document Feeder has
been adjusted for height, tighten the nut
which has been loosened in step 2.
Height Adjusting Screw
4344U023AA
4344U017AB
4344U015AA
5. Check the clearance between the document
scanning glass surface and the protrusion on
the Duplexing Document Feeder side.
* There should be a clearance of 0.5 mm or
less when the Duplexing Document Feeder
is pressed in the direction of the arrow.
• If the clearance is more than 0.5 mm, loosen
the nut on the right hinge as viewed from the
control panel side and turn the height adjust-
ing screw as necessary to adjust the height.
* If the clearance is large, turn the screw clock-
wise.
•
After the adjustment has been made, posi-
tively tighten the nut on the right hinge.
4344U019AB
1. Prepare a test chart (A4 or Letter) as shown.
2. Plug in the power cord and turn ON the
Power Switch of the copier.
4688U042AA
20 mm
3. Load the test chart in the Automatic
Document Feeder and make one 1-sided
copy five consecutive times.
NOTE
Load the test chart crosswise.
4344U021AA
4. Fold each of the sample copies as illustrated
and check for any deviation.
Specifications: 0 ± 3.0 mm
* If the deviation does not fall within the speci-
fied range, perform the following adjustment
procedure.
4688U001AB