Arctic Cat Sno Pro 120 2011, Service Manual

Page: 76 / 535

2-38
MD0275
6. Using Flywheel Puller, remove the flywheel.

NOTE: To ensure the cleanliness of the flywheel
magnets, place the flywheel (with the magnets facing
upward) on a clean bench.

NOTE: Do not remove the fan from the flywheel
assembly. If any damage or failure occurs with the fan
or the flywheel, it must be replaced as an assembly.
7. Remove the six cap screws securing the rear (intake-
side) shroud; then remove the shroud. Account for
the special washers.
MD0277
MD0067
8. Remove the rubber insulator grommet from the
crankcase; then remove two Phillips-head cap screws
securing the ignition timing sensor.
MD0075
MD0073
9. Remove the three Allen-head cap screws securing
the stator and remove it along with the timing sensor;
then carefully pull the wires through the hole in the
crankcase.
MD0072
CAUTION
To prevent damage to the crankshaft, install a protective
insert into the end of the crankshaft. The puller must
bottom on the insert and not on the crankshaft. Also, do
not thread puller bolts more than five threads into the
flywheel. Damage to the stator coils may result.
Manual
Table of Contents