Arctic Cat Sno Pro 120 2011, Service Manual

Page: 67 / 535

2-29
2
FS216A

NOTE: At this point on the 500/600 cc LXR, install
the pinion bracket assembly to the engine with two
cap screws (coated with green Loctite #609). Tighten
to 20 ft-lb.
FS190A
2. Install the MAG-side engine mounting bracket to the
engine with the cap screws (F) (coated with blue
Loctite #243). Tighten to 23 ft-lb (500/600 cc) or 36
ft-lb (800 cc).
742-205B
742-201A
3. On the 500/600 cc, install the front lower engine
plate to the engine with four cap screws (G) (coated
with blue Loctite #243). Tighten to 50 ft-lb.
4. Place the engine into the engine compartment from
the MAG-side; then tip the engine forward and sup-
port the engine in this position. Connect the coolant
hose to the thermostat housing.
FS194A
FS217A

NOTE: At this point on the 500/600 cc LXR, insert
the flex-drive shaft into the pinion drive and secure
with the two set screws.
800 cc
500/600 cc
CAUTION
Direct the hose clamp screw to the back side of the ther-
mostat housing to avoid contacting the chassis when
the engine is lowered and secured.
800 cc
500/600 cc
800 cc
Manual
Table of Contents