Arctic Cat Sno Pro 120 2011, Service Manual

Page: 283 / 535

5-22
4. Place the positive and negative cables on the starter
motor; then secure with the lock nuts. Tighten
securely.
FS205A
5. Connect the battery cables (positive cable first) to the
battery.
6. Install and secure the resonator and the expansion
chamber.

NOTE: When installing the exhaust manifold
springs, the long hook portion of the spring must be
attached to the exhaust manifold or premature spring
failure will result.

NOTE: To finalize the installing procedure, the air
silencer must be installed. Proceed to the appropriate
Air Silencer sub-section in Section 3.
Starter Motor (4-Stroke)
REMOVING
1. Remove the negative cable from the battery.

NOTE: To remove the starter motor, the air silencer
must be removed. Proceed to appropriate Air
Silencer sub-section in Section 3.
2. Remove cap screw (A) securing the positive cable to
the starter motor; then remove the two cap screws
(B) and remove the starter motor.
ZJ139A
DISASSEMBLING
1. Secure the starter motor in a suitable clamping
device; then remove the two long cap screws from
the starter motor.
ZJ140A
2. For assembling purposes, make alignment marks on
the bearing housing, magnet housing, and brush
assembly.
ZJ152A
3. Remove the bearing housing (A) and the magnet
housing (B) with armature from the brush assembly
(C).
ZJ141A
4. With the armature removed from the magnet hous-
ing, remove snap ring (D) from the armature.
Account for shim (E) and locking plate (F).
5. Using a flat-blade screwdriver, carefully remove the
seal from the bearing housing.
Manual
Table of Contents