Arctic Cat Sno Pro 120 2011, Service Manual

Page: 497 / 535

8-7
8
ZJ157A
2. Install the steering tie rod to the steering post and
secure with new lock nut. Tighten to 35 ft-lb.
ZJ156A
3. Secure the bearing bracket/steering post assembly to
the upper support plate with the bracket plates and
cap screws (coated with blue Loctite #243). Tighten
the cap screws to 96 in.-lb.
FS182A

NOTE: When installing the bracket plates, the wider
end of the plate must be directed up.
FS200A
4. On the Bearcat 570/F-Series/T-Series, place the rub-
ber exhaust bumper into position on the air silencer.
FS203A
5. On the Bearcat/F-Series/T-Series, place gaskets on
the resonator and exhaust manifold; then install the
expansion chamber. Secure the chamber to manifold
and upper frame with the springs.
6. On the standard models, place the handlebar/adjuster
block onto the steering post; then secure the handle-
bar to the steering post with the adjuster caps, four
cap screws, and lock nuts. Tighten cap screws
securely.
7. On the non-turbo TZ1/Z1, install the front end close-
off cover; then with the exhaust pipe mounting tab
(B) installed to the right-side cap screw, tighten the
cap screws (A) securely.
ZJ020A
Manual
Table of Contents