Arctic Cat Sno Pro 120 2011, Service Manual

Page: 214 / 535

3-35
3
INSTALLING
1. Join the air silencer halves and secure with the seven
machine screws; then install the dual intake boot and
secure with retaining clips.
2. Install the air temperature sensor.

NOTE: Before installing the air silencer, make sure
the gasline hose is routed over the air silencer.
3. Connect the air temperature sensor harness plug into
the sensor on the air silencer; then with screws of the
flange clamps directed properly as noted during
removing, install the air silencer and secure to the
chassis with the two torx-head cap screws. Secure
the flange clamps to the throttle body.

NOTE: To aid in installing the air silencer, apply a
coat of alcohol on the insides of the intake boot
openings.

NOTE: Install the air silencer at an angle positioning
it to the PTO-side throttle body first and tightening its
clamp; then working it back and forth and with an
angle tool, slide the mag-side air silencer boot onto
the throttle body and tighten its clamp. Once in place
and secured, carefully inspect that the boots are
properly seated to the throttle bodies.
ZJ015A
ZJ013A
4. Install the breather hose connecting the air silencer to
the separator tank; then connect the harness plug to
the sensor.
ZJ096B

NOTE: Before placing the gas tank into position on
the chassis, install the gasline hose to the tank, push
down on the connector until it snaps into place, and
route the vent hose to its proper position as noted
during removing.
IO054A
5. Install the gas tank to its proper position; then secure
the gas tank with the seat support assembly and
install the six torx-head cap screws. Tighten securely.
ZJ010A
6. Install the four cap screws securing the steering sup-
port plate to the steering support.
CAUTION
Make sure the gasline hose is properly locked to the
gas tank before continuing installing.
Manual
Table of Contents