Arctic Cat Sno Pro 120 2011, Service Manual

Page: 115 / 535

2-77
2
3. Using Flywheel Puller or suitable substitute, remove
the flywheel from the crankshaft by tightening the
puller bolt, striking the head of the puller bolt with a
hammer, and tightening again. Repeat this procedure
until the flywheel is free. Account for the key.
CM140

NOTE: To ensure the cleanliness of the flywheel
magnets, place the flywheel (with the magnets facing
upward) on a clean bench.

NOTE: On the 1000 cc, remove the Allen-head cap
screws securing the magneto case to the crankcase.
Account for the alignment pins.
CM144A
4. Remove the cap screw securing the ground wire to
the crankcase.
CM142A
5. Remove the Allen-head cap screw (A) securing the
stator lead wire plate to the crankcase; then remove
the Allen-head cap screws (B) securing the timing
sensors, remove the sensors, and account for the har-
ness grommets.
CM141C

NOTE: For assembling purposes, note the timing
sensor with the white dot (white connector) is located
in the upper mounting location of the crankcase.
IO016A
6. Remove the Allen-head cap screws securing the sta-
tor to the stator plate. Route the stator lead wire out
of the crankcase; then remove the stator assembly.
CM143A
7. Remove the cap screws securing the stator plate to
the engine; then remove the plate.
CAUTION
To prevent damage to the crankshaft, do not thread
puller bolts more than 1/2 in. into the flywheel. Damage
to the coils may result.
Manual
Table of Contents