Arctic Cat Sno Pro 120 2011, Service Manual

Page: 63 / 535

2-25
2
FS207A
FS208A
16. Drain the engine coolant (see Liquid Cooling System
- Section 3).
17. Remove the cable tie securing the gasline supply
hose to the MAG-side engine mounting bracket; then
loosen the clamp and remove the hose from the throt-
tle body assembly. Plug the end of the hose and
secure it up and out of the way.

NOTE: Note the routing and securing locations of
the hose for assembling purposes.
18. Loosen the flange clamps securing the throttle body
assembly to the flange; then move the throttle body
assembly forward and disconnect the oil-injection
cable/control rod from the oil-injection pump.
FS178A

NOTE: Remove the clamps from the intake flanges
to avoid damage during engine removing.
19. On the 500/600 cc, loosen the clamps securing the
coolant hoses connected to the cylinders beneath the
exhaust port and the throttle body assembly; then
remove the vent tube from the top of the cylinder
head.
CM030A
20. On the 800 cc, loosen the clamps securing the two
coolant hoses connected to the MAG-side and PTO-
side throttle body; then remove the vent tube from
the top of the cylinder head.
21. Move the throttle body assembly to one side out of
the way to a secure position.

NOTE: With the throttle body assembly out of the
way, disconnect the oil hose from the oil-injection
pump; then plug the oil hose.
FS179A
FS213A
22. Remove the cap screws securing the recoil starter;
then secure the recoil starter up and out of the way.
CAUTION
The gasline supply hose may be under pressure. Place
an absorbent towel around the connection to absorb
gasoline; then remove the hose slowly to release the
pressure.
500/600 cc
800 cc
Manual
Table of Contents