Arctic Cat Sno Pro 120 2011, Service Manual

Page: 387 / 535

7-19
7
SC025A
MS036A
4. Remove the cap screw and lock nut securing the
shock bracket/inner idler wheels to the slide rail.
SC026A
5. From one side, tap on the shaft of the assembly rear-
ward until the shaft is clear of the slide rail; then
remove the assembly.
SC027
6. Remove the outer spacers and idler wheels; then
slide the axle out of the shock bracket.

NOTE: On idler wheels with a non-removable bear-
ing, account for the flared spacers.
SC028
7. Remove the cap screw and lock nut securing the
shock absorber to the bracket.
MS086A
INSPECTING

NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is nec-
essary.
1. Inspect all front arm weldments for cracks or unusual
bends.
2. Closely inspect all tubing for cracks or unusual
bends.
3. Inspect the bearings, bushings, and front arm spacers
for wear or damage.
4. Inspect the shock absorber for damage and for any
signs of oil leakage especially at the point where the
shock shaft enters the shock body.
5. Inspect the shock absorber eyelet welds (at each end)
for any cracks, signs of separation, or for unthread-
ing.
INSTALLING
1. Secure the shock absorber to the shock bracket with
the cap screw and lock nut. Tighten securely.
Manual
Table of Contents