Arctic Cat Sno Pro 120 2011, Service Manual

Page: 187 / 535

3-8
FS230
3. Apply a small amount of grease to the oil seal lips.
4. Using a pair of snap ring pliers, install the snap ring
securing the oil seal in the crankcase.
FS228
5. Using the seal driver, carefully install the outer water
pump mechanical seal. Gently tap the seal down into
position until it seats itself against the crankcase.
FS232
6. Apply a light coat of grease to the sealing surface of
the oil-injection pump driveshaft; then install Oil
Seal Protector Tool at the end of the shaft. Twist the
shaft while pushing it through the oil and water
pump seals until the shaft gear engages with the
drive gear of the crankshaft; then remove the tool.
FS233A
IO025B
7. Position the shim on the oil pump end of the shaft;
then with the O-ring installed on the retainer, install
the oil-injection pump retainer.
IO026A
8. With the O-ring in place on the oil-injection pump,
align the pump with the shaft; then install the pump.
Secure with the cap screws (coated with blue Loctite
#243) (B) and tighten to 96 in.-lb. Place the lower
check valve into position; then secure with the gas-
kets and cap screw (A). Tighten to 48 in.-lb.
Manual
Table of Contents