Arctic Cat Sno Pro 120 2011, Service Manual

Page: 492 / 535

8-2
Steering and Body
This section has been organized into sub-sections for ser-
vicing steering and body components; however, some
components may vary from model to model. The techni-
cian should use discretion and sound judgment when
removing and installing components.

NOTE: Some illustrations and photographs used in
this section are used for clarity purposes only and
are not designed to depict actual conditions.

NOTE: Critical torque specifications are located in
Section 1 of this manual.
SPECIAL TOOLS
A special tool must be available to the technician when
servicing the steering and body systems.

NOTE: Special tools are available from the Arctic
Cat Service Parts Department.
Steering Post
(CFR/Crossfire/M-Series)
REMOVING
1. Using a suitable handlebar support stand, tip the
snowmobile on its PTO-side.
2. From beneath the front end, remove the lock nut and
washer securing the steering post to the steering post
stop.
FC199
3. Tip the snowmobile upright. Remove the handlebar
pad.
4. Remove the cable ties securing the wiring and brake-
line hose and throttle cable to the steering post.

NOTE: Remove the routing clips securing the brake
hose and wiring to the steering support.
5. On the standard models, remove four lock nuts, cap
screws, and adjuster block caps securing the handle-
bar to the adjuster block. Secure the handlebar out of
the way.
0743-442
6. On the Sno Pro and HCR models, remove the four
Allen-Head cap screws securing the handlebar to the
steering post and account for the adjusting block
cover.
0743-467
7. Remove the two screws from the handlebar pad; then
remove the self-tapping screw securing the retainers
(A) to the riser block assembly. Remove the retainer.
0744-927
8. Unlock the cam lever and unthread the lever from the
lock rod (B); then remove the lock rod and account
for the two bottom cap springs (C).
Description p/n
Shock Spring Removal Tool 0644-057
Handlebar Stand 5639-152
CAUTION
Do not rotate the handlebar to a position allowing air
to enter the brake system.
Manual
Table of Contents