Arctic Cat Sno Pro 120 2011, Service Manual

Page: 59 / 535

2-21
2
CM132A
CM133A

NOTE: Install the two front lower cap screws first to
properly align the remaining cap screws.
CM133B
19. Slide the APV cable drums into the servomotor actu-
ator; then place the cable housings into position in
the servomotor. Secure the cable housings with the
cable holder.
CM127
20. Rotate the servomotor clockwise to remove any
slack from the cables; then install the servomotor
retaining clip.
TZ069A
21. Check APV cable adjustment. See Arctic Power
Valve (APV) System in Section 3.

NOTE: Before installing the drive clutch, be sure to
wipe both the crankshaft taper and clutch mounting
taper clean using a clean towel.
22. Place the drive clutch into position on the crankshaft
and secure with the cap screw and lock washer.
Tighten to 55 ft-lb (1000 cc) or 51 ft-lb (800 cc).

NOTE: To aid in proper tightening of the drive clutch
cap screw, apply oil to the threads of the cap screw
prior to installing.
23. Install the alignment washers (if applicable); then
install the driven pulley on the gear case input shaft.
Tighten the cap screw to 32 ft-lb.
CM125A
CAUTION
When installing the drive clutch, do not tighten the
clutch cap screw with any kind of impact tool. Tighten
cap screw using a hand torque wrench only. Failure to
do so could result in stationary sheave damage.
CAUTION
Do not allow the driven pulley to “float” on the input
shaft. Damage to the driven pulley will occur.
CAUTION
Do not apply Loctite to the cap screw or damage to the
gear case will occur.
Manual
Table of Contents