Arctic Cat Sno Pro 120 2011, Service Manual

Page: 439 / 535

7-71
7
1. Clean the slide rail using parts-cleaning solvent and
compressed air.
2. Inspect the slide rail for cracks. If any cracks are
found, replace the slide rail.
3. Using a straightedge, inspect the slide rail for any
unusual bends. With the slide rail removed, place the
straightedge along the bottom surface of the slide
rail. If the rail is found to be bent, it must be
replaced.
AG536D
INSTALLING

NOTE: Apply a light coat of grease to the slide rail
surface to aid in installing a new wear strip. Use a file
to remove any sharp edges on the lower portion of
the rail.
1. Align the wear strip with the openings (windows) in
the track and from the back, start the wear strip onto
the rail; then using a block of wood and a hammer,
drive the wear strip forward into position.
739-884A
2. Secure with a machine screw and lock nut. Tighten
to 50 in.-lb.
End Caps

NOTE: The skid frame does not have to be removed
for this procedure.
REMOVING
1. Remove the lock nut and cap screw securing the end
cap.
FZ026A
2. Using a hammer, tap the end cap off the rail.
CLEANING AND INSPECTING

NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is nec-
essary.
1. Inspect the end cap area of the slide rail for cracks
and wear.
FZ027A
2. Inspect the end cap for any signs of cracking or wear.
FZ028A
3. Clean both the slide rail area and the end cap. Using
compressed air, clean the areas of dirt and gravel.
! WARNING
Always wear an approved pair of safety glasses when
using compressed air.
! WARNING
Always wear an approved pair of safety glasses when
using compressed air.
Manual
Table of Contents