Arctic Cat Sno Pro 120 2011, Service Manual

Page: 445 / 535

7-77
7
FZ045
7. With a suitable driving tool, install the rear upper
idler wheel on the idler arm.
FZ046
MS072A
8. Install the idler spacer collar onto the idler arm.
FZ047
9. Place the flared bushing with a thin flat washer
through the notched side of the pivot arm assembly.

NOTE: If the flared bushing in the pivot arm is
loose, it must be cleaned and green Loctite #609
must be applied to it prior to installation.
10. Align the marks on the idler arm to the centerline of
the pivot arm assembly. Secure the pivot arm to the
idler arm with cap screws and lock nuts. Tighten to
20 ft-lb.
FZ048A

NOTE: When tightening the pivot arm lock nuts,
tighten the lower lock nut first or binding may occur.
Make sure the flared side of the bushing is directed
outward.
FZ048B
11. Grease the idler arm and rear arm grease fittings with
a low-temperature grease.
CAUTION
When driving the idler wheel onto the idler arm, use a
tool to contact the inside race of the bearing or dam-
age to the wheel or bearing may occur.
Manual
Table of Contents