Arctic Cat Sno Pro 120 2011, Service Manual

Page: 169 / 535

2-131
2
TZ099A

NOTE: Place the upper frame into position and
install the clip securing the wire harness to the steer-
ing support gusset.
TZ098A
13. Install the lower air silencer to the turbocharger and
tighten the hose clamp (A) securely; then with the
upper frame in position between the steering support
and the front end, install the two cap screws and lock
nuts (B) securing the frame to the front end. Install
the remaining cap screw (C) securing the air silencer
and skid plate two the upper frame.
743-995B
14. Install the gas hoses into the clip and with the upper
air silencer in place, install cap screw (A) securing
the upper frame, gas hose clip, and air silencer to the
steering support; then install the remaining cap screw
(B) securing the air silencer to the upper frame.
743-995A
15. Install the four remaining cap screws securing the
upper frame/support gusset to the steering support.
16. Install the coolant/separator tank assembly and
secure to the right-side upper frame with cap screw
and two lock nuts. Tighten securely; then install the
hoses to the proper locations on the tank assembly
and water pump as noted during removing. Secure
with clamps.
TZ081A

NOTE: At this time, make sure the coolant hoses
from the coolant tank to the throttle body assemblies
and throttle bodies to the left-side cylinder head are
secured and properly routed. On the turbo models,
make sure the throttle body coolant return hose is
secured.
ZJ018B
Manual
Table of Contents