Arctic Cat Sno Pro 120 2011, Service Manual

Page: 234 / 535

4-8
AH137
10. Place the E-clip into position on the jet needle. From
the bottom of the jet needle, slide the E-clip washer
up against the E-clip. Place the jet needle into the
piston valve.

NOTE: Place the E-clip in the proper position as
noted in disassembly.
725-266C
11. Place the cable retainer into the piston valve and
secure with the Phillips-head screw. Guide the cable
end down into the cable retainer slot and slide the
cable end to the center of the piston valve. Release
the spring and retainer plate to lock the cable in posi-
tion.
AH075

NOTE: The round part of the cable end must come
through the hole in the plate/piston valve. If it
doesn’t, the cable isn’t assembled to the piston valve
correctly.
12. Thread the plunger cap onto the choke cable. Place
the spring over the cable end and compress. Position
the cable end into the starter plunger and release the
spring.
INSTALLING
1. Place the piston valve into position making sure the
full-length groove in the piston valve is aligned with
the pin in the mixing chamber bore; then thread the
mixing body top onto the carburetor and tighten
securely.
CM056A

NOTE: Prior to threading the mixing body top onto
the carburetor, assure the rubber washer is posi-
tioned correctly on the body top.
2. Making sure the mixing body top plate is properly
positioned, secure the mixing body top by tightening
the screw and lock washer.
3. Connect the fuel hose to the carburetor inlet fitting;
then using Fuel Hose Clamp Tool, secure the hoses
to the carburetor with the clamps.
4. Place the carburetor into position in the flange and
air silencer boot; then tighten the flange clamp mak-
ing sure the carburetor is level. Do not over-tighten
the flange clamp as it will damage the carburetor
flange.
TZ102A

NOTE: Slide the carburetor into the air silencer
boot; then slide the carburetor into the flange.
CAUTION
When installing the carburetors, make sure the gasline
hoses are properly routed to avoid premature wear
and/or contact with exhaust components.
Manual
Table of Contents