Arctic Cat Sno Pro 120 2011, Service Manual

Page: 58 / 535

2-20
CM131B

NOTE: After securing the oil-supply hose to the oil
pump, remove the bleed screw to allow any air in the
hose/pump to be released.
CM184A

NOTE: Confirm the two coolant hoses running to
the throttle bodies are accessible to connect and the
gasline hose and oil pump linkage are accessible.
14. Place the throttle bodies into position and secure
with the flange clamps; then connect the gasline hose
to the throttle body assembly and tighten the clamp
securely.
FC051
15. Install the oil pump linkage arm to the throttle body
pulley; then verify oil-injection pump synchroniza-
tion (see Section 4).
CM129B
16. Connect the two coolant hoses to the throttle body
assembly; then secure with the clamps.
CM131A
17. With the air silencer boot properly positioned on the
throttle body assembly, install the silencer and secure
with the hold-down and the torx-head cap screw.
CM026A
18. Install the side-plate brace onto the chassis and
secure the brace and the steering support with the cap
screws (coated with blue Loctite #243). Tighten to
20 ft-lb.
CAUTION
When installing the throttle bodies, make sure the
gasline hose is properly routed to avoid premature wear
and/or contact with exhaust components.
Manual
Table of Contents