Arctic Cat Sno Pro 120 2011, Service Manual

Page: 212 / 535

3-33
3
ZJ100A
2. Remove the two torx-head cap screws (A) securing
the console to the chassis; then lift up the rearward
end of the console and disconnect the console har-
ness plug-in. Remove the console.
741-744A
3. Remove the torx-head cap screws securing the upper
front/rear panels (C) and the handlebar close-off
panel (B) along with the body screws securing the
knee-pads to the steering support.
4. Remove the torx-head cap screws (D) securing the
upper front panel to the front bumper.
5. Remove the four cap screws securing the upper bear-
ing bracket to the upper support plate.
ZJ097A
6. Remove the four cap screws securing the support
plate to the steering support.
ZJ009A
7. Remove the six torx-head screws securing the seat
support assembly to the tunnel; then slide the support
back out of the way.
ZJ010A
8. Disconnect the fuel pump four-wire connector; then
slide the gas tank rearward enough to gain access to
the gasline hose connector.
ZJ011A
9. Compress the clip on the gasline hose connector and
remove the hose from the gas tank; then disconnect
the vent hose and remove the gas tank.
Manual
Table of Contents