Arctic Cat Sno Pro 120 2011, Service Manual

Page: 50 / 535

2-12
0742-854
11. Route the gasline hose to the throttle body assembly
and secure the hose to the fuel rail. Tighten the clamp
securely; then using a cable tie, secure the hose to the
MAG-side engine mounting bracket.
12. Install the two coolant hoses to the MAG-side and
PTO-side of the crankcase (below the exhaust ports)
and the overflow hose; then tighten the coolant hose
clamps and the throttle body flange clamps.
FS271A
13. Apply a thin coat of high-temperature silicone sealant
to each exhaust port; then install the exhaust gaskets.
14. Apply a thin coat of high-temperature silicone seal-
ant to the mating surfaces of the exhaust manifold;
then install the exhaust manifold and secure with the
nuts. Tighten in a crisscross pattern to 15 ft-lb.
CM035
15. Install the side-plate brace onto the chassis and
secure the front of the brace with the four cap screws
(coated with blue Loctite #243). Tighten securely.
CM210A

NOTE: Install the two front lower cap screws first to
properly align the remaining cap screws.
16. After securing the front of the brace, secure the rear
of the brace and the steering support to the chassis
with the cap screws (coated with blue Loctite #243).
Tighten to 20 ft-lb.
CM209A
17. Fill the cooling system (see Liquid Cooling System
in Section 3).
18. Place the recoil starter into position and secure the
starter with the cap screws. Tighten to 96 in.-lb.
FC052
19. Slide the APV cable drums into the servomotor actu-
ator; then place the cable housings into position in
the servomotor.
CAUTION
When installing the throttle bodies, make sure the
gasline hose is properly routed to avoid premature wear
and/or contact with exhaust components.
Manual
Table of Contents