Arctic Cat Sno Pro 120 2011, Service Manual

Page: 42 / 535

2-4
19. Remove the cap screw and lock nut securing the wir-
ing harness clamp to the chassis; then remove the
spark plug wires from the spark plugs. Disconnect
the coil wire and CDI connectors and route and
secure the harness to the engine to avoid damage
when removing the engine from the chassis.
FZ012A

NOTE: For assembling purposes, note the routing
and securing locations of the wiring harness and the
routing of the oil hoses and impulse line.
20. Turn the steering all the way to the right; then rotate
the engine allowing enough room to lift it up and out
of the front of the chassis.
FZ013
21. Remove the two cap screws securing the rear PTO-
side crankcase snubber bracket.
FZ022A
22. Remove the four cap screws securing the engine
plate to the engine; then remove the plate.
FZ014
Installing
1. Install the engine plate to the engine with four cap
screws. Tighten to 36 ft-lb.
FZ025
2. Install the PTO-side crankcase snubber bracket with
two cap screws; then tighten to 20 ft-lb.
FZ022A
3. With the steering turned all the way to the right,
install the engine into the chassis and position the
engine forward of the mounting locations to access
the oil pump and electrical connectors.
Manual
Table of Contents