Arctic Cat Sno Pro 120 2011, Service Manual

Page: 501 / 535

8-11
8
3. Place the steering arms/drag link assembly into posi-
tion in the chassis; then secure the arms (D) with
axles (F) to the chassis with cap screws and new lock
nuts (C). Tighten the lock nuts to 20 ft-lb.
4. Install the left-side spindle tie rod and steering tie rod
to the drag link with cap screw (threads coated with
green Loctite #609) and new lock nut (B); then
install the remaining tie rod to the drag link with cap
screw (threads coated with green Loctite #609) and
new lock nut (A). Tighten to 35 ft-lb.
5. On the non-turbo models, install the front end close-
off cover and with the exhaust pipe mounting tab (B)
in position on the right-side cap screw, tighten the
two cap screws (A) securely.
ZJ020A

NOTE: On the turbo models, position the inter-
cooler into the grommets of the mounting bracket;
then connect the intercooler hoses to the turbo and
to the intake plenum. Tighten all hose clamps
securely.
6. On the Z1, install the exhaust pipe and secure the
pipe to resonator, manifold, and the mounting tab
with springs; then connect the oxygen sensor and
install the hood.
7. Using an all-temperature grease, grease the steering
arms; then verify free movement of the steering com-
ponents.
ZJ165A

NOTE: On the liquid-cooled F-Series to finalize the
installing of the drag link, proceed to Air Silencer
(Liquid Cooled F-Series 2-Stroke) sub-section in Sec-
tion 3 and follow the INSTALLING procedure.
Tie Rods/Steering Link
(CFR/Crossfire/M-Series)
REMOVING
1. Remove and discard the lock nut securing the steer-
ing tie rod to the upper arm of the steering shaft.
Account for the washer.

NOTE: Note that the tie rod is installed on the top
side of the upper arm for installing purposes.
FC206
2. Remove the Allen-head cap screw securing the tie
rod end to the steering arm.
CM266A
3. Remove the cap screw and lock nuts securing the tie
rod to the right-side spindle arm. Discard the lock
nuts.
CM267A
4. Remove and discard the lock nut and washer secur-
ing the steering link to the steering arm.
Manual
Table of Contents