Arctic Cat Sno Pro 120 2011, Service Manual

Page: 211 / 535

3-32
742-207A
3. Install the body screws and lock nuts (C) from each
side and the self-tapping screws (B) from each side
securing the front bumper assembly to the chassis.
Tighten all hardware securely.
4. Connect the air temperature sensor and place the sen-
sor harness beneath the intake duct; then install the
duct into the silencer.

NOTE: To aid in installing the duct, it can be helpful
to apply a thin film of WD-40 to the air silencer seal
and to work the duct back and forth until the sleeve of
the duct is properly seated into the silencer.
5. Secure the intake duct to the upper frame with the
cap screw. Tighten securely.

NOTE: If the ECU was removed to gain access to
the duct cap screw, install the ECU using the two cap
screws. Tighten the cap screws securely; then con-
nect the harness plug-ins to the ECU.
FS202A
6. Using the illustration following step 2, secure the
left-side rear spar panel to the gas tank and support
tube with the three torx-head screws (D). Tighten the
screws securely.
7. Install the seat; then install the machine screw
(threads coated with blue Loctite #243) to the right
side of the seat support.
8. Place the rubber exhaust bumper into position on the
air silencer.
FS203A
9. Place gaskets on the resonator and exhaust manifold;
then install the expansion chamber. Secure the cham-
ber to manifold and upper frame with the springs.
10. Secure the console to the steering support with the
torx-head screws and tighten the screws securely;
then close the left-side and right-side access panels
and close the hood.
0743-777
Air Silencer
(1100 cc Non-Turbo)

NOTE: A number of servicing procedures for the
engine-related items require the air silencer be removed
and installed. Pay close attention to the

NOTE: pre-
ceding a particular servicing procedure that will direct
the technician to this sub-section for removing/install-
ing the air silencer.
REMOVING/INSPECTING/CLEANING
1. Adjust the seat to the lowest position; then while lift-
ing on the top forward part of the seat, remove the
machine screw from the right side of the seat support
assembly. Remove the seat.
CAUTION
Make sure to place the sensor harness beneath the
intake duct to avoid contact with exhaust components.
Manual
Table of Contents