AirStage AO54FJ, Service Manual

Page: 7 / 169

01-02
OPERATION
OPERATION
indicator
(Red)
MANUAL AUTO
SET TEMP (+)
ACL
FAN CONTROL
(1) Press and hold 3 sec the "MANUAL AUTO" button
of indoor unit.
Pi Pi Pi
(2) Press the ACL button, with pressing the
FAN CONTROL and SET TEMP (+) button.
(1) Press the set temp (+) or (-) button to select the
custom code adjust to indoor unit setting.
(2) Press the VERTICAL AIR FLOW to send
the code to the indoor unit.
+
-
CUSTOM CODE
( - - - )
The initial setting is " "
(1) Press the MASTER CONTROL to
change in to address setting mode.
(2) Make sure bottom number is "01"
If other than "01" press the SET TEMP (+) or (-)
to select "01".
(3) Press the FAN CONTROL button.
Address data display flashing.
(4) Press the SET TEMP (+) or (-) button to select the
address.
1. Address should be within "00" to "07".
2. Each unit should have different address.
:
+
-
SET "01"
:
Address data
:
+
-
Range
00 - 07
A
Pi Pi
Correct code:
Wrong code:
No Response
1. Switching selection of address setting mode.
2. Selection and confirmation of custom code.
3. Address setting
1-1-2 Address setting
*
*