Agilent Technologies 8360B, User Manual, Page: 351 / 496

SCPI COMMAND SUMMARY
POW er:ALC:ST A T e POW er:SEARch P o w er Switc h Action
ON ON ALC is momen tarily closed to
level at the requested p ow er,
and then the mo dulator is set to
the same voltage in op en lo op
mo de. This rep eats automatically
any time that the p ow er level or
frequency is c hanged.
ON OFF Normal mo de.
ON ONCE Immediately p erforms a p ow er
searc h. This leaves PO W er:SEARch
in the ON p osition.
OFF not applicable Mo dulator setting is
explicitly set by user.
POWer:SLOPe <num>[DB/freq
suffix]|MAXimum|MINimum|UP|DOWN
POWer:SLOPe? [MAXimum|MINimum]
Sets and queries the RF slop e setting (dB p er Hz).
FREQ:MODE Aect on Slop e
CW or LIST Rotates around 0 Hz.
SWEep or
STEP
Rotates around the start frequency .
The *RST v alue is 0.
POWer:SLOPe:STATe ON|OFF|1|0
POWer:SLOPe:STATe?
Sets and queries the p o w er slop e state. *RST v alue is 0.
POWer:SPAN <num>[DB]|MAXimum|MINimum|UP|DOWN
POWer:SPAN? [MAXimum|MINimum]
The coupling equations for p o w er sw eep are exactly analogous to
those for frequency sw eep. P o w er sw eep is allo w ed to b e negative,
unlik e frequency sw eeps. *RST v alue is 0.
POWer:STARt <num>[lvl suffix]|MAXimum|MINimum|UP|DOWN
POWer:STARt? [MAXimum|MINimum]
Default units and units for query resp onse are determined b y the
command UNIT:POWer . The coupling equations for p o w er sw eep
are exactly analogous to those for frequency sw eep. P o w er sw eep is
allo w ed to b e negative, unlik e frequency sw eeps.
*RST v alue is 0 dBm.
POWer:STATe ON|OFF|1|0
POWer:STATe?
Sets and queries the output p o w er on/o state. *RST v alue is OFF .
S-44 Operating and Programming Reference