Agilent Technologies 8360B, User Manual, Page: 339 / 496

SCPI COMMAND SUMMARY
DIAGnostics:RESult?
Returns the follo wing information:
<result>, <test failure>, <manual entry point>
where, <result> is one of the following:
0 Diagnosis successful.
1 Cannot diagnose; full selftest m ust b e executed rst.
2 No failures found|all selftests passed.
01 Cannot diagnose; diagnosis routine failed to isolate failure.
(softw are fault)
<test failure> is the test n um b er of the most relev an t failure
( 0999 if parameter is not used, as in <result > of 1).
<manual entry point> is a string resp onse that iden ties the
paragraph n um b er in the A gilent T e chnolo gies 8360 B-Series Swept
Signal Gener ator/ 8360 L-Series Swept CW Gener ator Servic e Guide
to b egin the troublesho oting pro cedure.
DIAGnostics:TEST:CONTinue
Causes the selftest execution to con tinue when paused for raw data
examination. Do es nothing in other conditions.
DIAGnostics:TEST:DATA:DESC?
Returns the description string of the raw data examined during a
selftest. It returns \ " in other conditions.
DIAGnostics:TEST:DATA:MAXimum?
Returns the upp er test limit for the raw data p oint examined.
Returns \0" in other conditions.
DIAGnostics:TEST:DATA:MINimum?
Returns the low er test limit for the raw data p oint examined.
Returns \0" in other conditions.
DIAGnostics:TEST:DATA:VALue?
Returns the raw data v alue for the raw data p oint examined.
Returns a \0" in other conditions.
DIAGnostics:TEST:DISable {<num>}1*?|ALL
Prev en ts the listed selftests from b eing selected. If ALL is sen t then
all of the selftests are disabled. *RST causes DIAG:TEST:ENAB ALL to
execute.
DIAGnostics:TEST:ENABle {<num>}1*?|ALL
Enables the listed selftests to execute. If ALL is sen t then all of the
selftests are enabled. *RST causes DIAG:TEST:ENAB ALL to execute.
S-32 Operating and Programming Reference