Agilent Technologies 8360B, User Manual, Page: 188 / 496

CONNECTORS
Figure C-3. Interface Signals of the Source Module Connector
The co des indicated on the illustration ab o v e translate as follo ws:
MOD D0 Source mo dule data line zero. Signals MOD D0
through MOD D3 are the mm source mo dule
data bus lines (bi-directional).
MOD D1 Data line one.
MOD D2 Data line t w o.
MOD D3 Data line three.
MOD C0 Source mo dule con trol line zero. Signals MOD
C0 and MOD C1 are the con trol lines for the
read/write to and from the mm source mo dule.
MOD C1 Con trol line one.
CLAMP CNTL Source mo dule clamp con trol (not used).
MOD SENSE Source mo dule sense. A 1mA curren t is injected
on this line b y the mm source mo dule to
indicate its presence. This signal alwa ys equals
0 V.
L MOD RF OFF Lo w = RF o. Source mo dule RF is turned o.
EXT L VL RET Source mo dule external lev eling return.
EXT L VL Source mo dule external lev eling input, from the
mm source mo dule.
0.5V/GHz In ternal 0.5 V/GHz to the mm source mo dule.
015V P o w er supply . Range is 014.25 to 015.90 V.
+15V P o w er supply . Range is +14.25 to +16.40 V
+8V P o w er supply . Range is +7.75 to +8.25 V.
+5V P o w er supply . Range is +4.75 to +5.45 V.
DIG GND Digital ground.
MOD ANLG GND Source mo dule analog ground.
ANLG GND RET Analog ground return.
C-10 Operating and Programming Reference