Agilent Technologies 8360B, User Manual, Page: 337 / 496

SCPI COMMAND SUMMARY
CORRection:FLATness {<num>[freq suffix],<num>[DB]}2*801
CORRection:FLATness?
Sets and queries an array of up to 801 frequency-correction
pairs. This correction information is used to create a correction
array that can b e added to the in ternal calibration array . The
correction en tered is at the asso ciated frequency . F requencies in
b et w een frequency-correction pair v alues are determined b y linear
in terp olation. If a v alue of ST AR T or STOP frequency is sp ecied
that is outside the limits of the sp ecied frequencies, the correction
applied at those p oints is 0 dB. After *RST, returns a
MinFreq, 0 DB, MaxFreq, 0 DB resp onse.
CORRection:SOURce[i] ARRay|FLATness
CORRection:SOURce[i]?
Sets and queries the source of correction.
CORRection:FLATness:POINts? [MAXimum|MINimum]
Returns the n um b er of frequency-correction pairs en tered using the
CORR:FLAT command. After *RST, the v alue is 2.
CORRection[:STATe] ON|OFF|1|0
CORRection[:STATe]?
Sets and queries the switch on the users ALC correction system.
The *RST v alue is OFF.
DIAGnostics:ABUS? <num>
Reads the analog bus no de n um b er and returns the n um b er of
milliv olts.
DIAGnostics:ABUS:AVERage <num>
DIAGnostics:ABUS:AVERage?
Sets and queries the n um b er of ADC a v erages to use during the read
ADC query . After *RST, the v alue is 1.
DIAGnostics:ABUS:STATus?
Queries the status of the prior ADC reading. The resp onse is a single
b yte that is bit-enco ded to mean:
Bit 0 Set to 1, if ADC timed out (hardware fault).
Bit 1 Set to 1, if reading w as unsettled.
Bit 2 Set to 1, if out of range o ccurred.
S-30 Operating and Programming Reference