Fault tracing 401
D202
Reverse slow down
limit
Slowdown command is active
in the reverse (down) direction
based on the selection in
parameter
76.07
Reverse slow
down limit
.
Run the motor in the opposite direction
and deactivate the Slowdown command,
or let the drive run with the limited speed
reference.
D205
Forward stop limit
Stop limit command is active
based on the selection in
parameter
76.04
Forward stop
limit
.
Check the wiring of the forward stop limit
connection.
Run the motor in the opposite direction
and deactivate the forward stop limit
command.
D206
Reverse stop limit
Stop limit command is active in
the reverse direction based on
the selection of
76.06
Reverse
stop limit
.
Check the wiring of the reverse stop limit
connection.
Run the motor in the opposite direction
and deactivate the reverse stop limit
command.
D208
Joystick reference
check
Speed reference is greater
than +/- 10% of the minimum
or maximum scaled value of
the used joystick reference, the
joystick zero position input
(
20.214
Joystick zero position
)
is active, and the delay defined
with parameter
20.215
Joystick
warning delay
has elapsed.
Check the wiring of the joystick zero
position input.
Check the wiring of the analog input
reference signal of the joystick.
D209
Joystick zero position
Drive does not accept a start
command because of a wrong
state of the joystick zero
position input (
20.214
Joystick
zero position
).
Check the wiring of the joystick zero
position input.
D20A
Fast stop
Fast stop command (
20.210
Fast stop input
) is activated.
Deactivate the Fast stop command.
D20B
Power on
acknowledge
Power on acknowledge circuit
is open.
Check the wiring and the setting of
parameter
20.212
Power on
acknowledge
.
Code
(hex)
Warning / Aux. code
Cause
What to do
ACS380 FW.book Page 401 Friday, May 4, 2018 4:18 PM
ghv Vertriebs-GmbH
| Am Schammacher Feld 47 | 85567 Grafing | T 49 80 92 81 89 0 | [email protected] |
www.ghv.de
