ABB ACQ80, Firmware Manual

Page: 31 / 390

Startup, control with I/O and ID run 31
The control panel returns to the previous
view and warning message
Identification
run is shown at the top for a few seconds.
Control panel LED starts blinking green to
indicate an active warning (
AFF6
).
The
AFF6
warning view is shown when no
key has been pressed for one minute.
Pressing ( How to fix ) shows text
informing that the ID run will be done at the
next start. You can hide the warning view by
pressing ( Hide ).
Press the start key ( ) to start the ID run.
In general, ABB recommends not to press
any control panel keys during the ID run.
However, you can stop the ID run at any time
by pressing the stop key ( ).
During the ID run the arrow is rotating at the
top.
After the ID run is completed, text
ID run
done is shown. The LED stops blinking.
If the ID run fails, fault
FF61 ID run
is shown.
See chapter
Fault tracing
on page
303
for
more information.