Yamaha WR450F, Руководство по эксплуатации для владельца

Страница: 186 / 794

2 - 29
SPEC
CABLE ROUTING DIAGRAM
Í
Fasten the catch tank breather
hose and catch tank hose to the
rear frame. Clamp them close
to where they are joined to the
frame. Fasten the pipe tightly
enough not to crush it. Locate
the clamp end facing toward the
rear of the frame with the tie
end facing downward.
Î
Fasten the (three) CDI unit
leads and taillight lead to the
rear frame. Locate the clamp
end facing toward the upper
side of the frame and cut off the
tie end.
Ï
Connect the negative battery
lead to the battery negative ter-
minal.
Ð
Connect the negative battery
lead to the wire harness.
Ñ
Fasten the wire harness to the
rear frame. Locate the clamp
end facing toward the upper
side of the frame and the tie
end toward the inside of the
frame. Clamp the wire harness
at the marking.
Ò
Pass the wire harness, starter
relay lead, starting circuit cut-off
relay lead and negative battery
lead through the hole in the
relay holder.
Ó
Fasten the (three) CDI unit
leads and taillight lead to the
rear frame. Locate the clamp
end facing toward the lower
side of the frame and cut off the
tie end.
Ô
Fasten the taillight lead to the
rear frame. Locate the clamp
end facing toward the upper
side of the frame and cut off the
tie end.
Õ
Do not allow the taillight lead to
slacken.
Ö
Locate the CDI unit lead
between the CDI unit and rear
fender.
×
Locate the CDI unit coupler in
the clearance between the
upper side of the CDI unit and
lower side of the catch tank
stay.
Ø
Locate the CDI unit lead
between the CDI unit and rear
frame.