Wallace Perimeter Security ALPHA, Руководство по установке и обслуживанию

Страница: 22 / 182

22
wallaceperimetersecurity.com
Phone: 866.300.1110
SAFETY STANDARDS - INSTALLER'S RESPONSIBILITY
- Incorporate a security feature to prevent unauthorized use.
• The gate operator must be properly grounded and the incoming power voltage must match the voltage
label on the junction box.
• Install enough external entrapment protection sensors so that pedestrians are protected from
entrapment in both directions of the gate travel and all hazard areas and possible pinch points are
fully protected. Review the information found in “External Entrapment Protection Sensors” on page
25 and “UL 325 Compliant Sensors” on page 29 .
• Install the supplied WARNING signs on the inside and outside of the gate so they are clearly visible
from both sides of the gate. Installing the signs is a requirement for UL 325 compliance.
• Connect radio and other remote access (non-resetting controls) to the RADIO OPTIONS terminals.
• Open and close the gate to confirm that it was properly installed and to ensure reduced risk of
entrapment. Verify the clearance between the gate and adjacent structures per UL 325 Safety
Standards. Have a qualified gate technician test the gate monthly.
• When you complete the installation, show the end user how to:
- Remove the cover. Turn the power off and on to demonstrate relearn limits after DC/AC cycles.
- Turn the DC power switch off, which disengages the motor, and manually push the gate.
- Use the Stop Button located on the side of the control box. It can be accessed through a hole in the
cover.
Gate operator instructions must be
given to the owner per UL 325 Safety
Standards.