Wallace Perimeter Security ALPHA, Руководство по установке и обслуживанию

Страница: 130 / 182

130
wallaceperimetersecurity.com
Phone: 866.300.1110
USER RELAYS - PROGRAMMING PROCEDURE
Table 9. User-Programmable User Relays - Function Options
No� Name Description
5 Warn before/during
operate output
Controls an external warning device. This output operates at
the same time as the internal “warn before operate” buzzer.
6 Gate Lock output Controls external solenoid locks or magnetic locks. In both
directions of travel, this output is activated about 7/10ths of a
second before the operator starts moving the gate and remains
active while moving as well as for a few seconds after stopping.
7 Gate forced open output Activated if the gate is forced off the closed limit switch
and operator is not able to restore the gate to fully closed
within four seconds. The alarm resets itself in 30 seconds.
8 Gate open too long
output
Activates when the gate is open longer than a user-selected
period of time. Adjustable from a 0 second to 135 second delay in
30-second increments.
Note: TL - OPEN TIME ALERT adjustments can be made in the
Installer Menu.
9 Safety Mode Alert output Activated when system is in Safe Mode or Entrapment Mode.
10 Entrapment Mode Alert
output
Activated only when system is in Entrapment Mode.
11 Unauthorized Vehicle
Entry output
Activated when a second vehicle enters from the outside without
a valid input from an access control device. The OOLD and IOLD
loops must be capable of being triggered at the same time for this
relay to ever activate. This output releases when an access control
input signals open or the gate reaches the close limit position.
12 Outside Obstruction
Vehicle Detector output
Interlocks an entry device to prevent pedestrian use. This output is
active whenever the Outside Obstruction Loop Detector is tripped.
13 Loitering Alert Indicates a vehicle is loitering on the Outside Obstruction Loop.
Adjustable from a 0 second to 135 second delay in 30-second time
intervals.
Note:
LT - LOITERING ALERT adjustments can be made in the
Installer Menu.