Wallace Perimeter Security ALPHA, Руководство по установке и обслуживанию

Страница: 80 / 182

80
wallaceperimetersecurity.com
Phone: 866.300.1110
INSTALLING THE EXTENDED BATTERY BACKUP KIT
Installing the Extended Battery Backup Kit
Wallace Perimeter Security offers an extended DC
power back up option with two 50Ah batteries.
Contact Wallace Perimeter Security parts
department to order extended battery backup kit
with base extension.
To install the extended battery backup kit:
1. Turn off the DC and AC power switches.
2. Place the accessory tray on the studs inside
the base riser.
3. To access the 8Ah batteries and disconnect
its wires, cut the two black wire ties and slide
the 8Ah batteries through the access window.
Another option is to remove the four screws
that hold the control box to the chassis.
4. Place the two 50Ah batteries on the tray.
5. Attach the blue wire from the red terminal on
one 50Ah battery to the black terminal on the
other 50Ah battery.
6. Run the red and black wires (disconnected
from the 8Ah batteries) through the hole in
the support bracket.
7. Using the wires supplied in the 50Ah battery
kit, attach the red wire to the red positive
terminal on the 50Ah battery. Connect its
opposite end to the red lead exiting the
support bracket.
8. Connect the black wire to the black negative
terminal on the 50Ah battery. Connect its
opposite end to the black lead exiting the
support bracket.
9. Access the Installer Menu on the SmartDC
Controller.
10. Change the Battery Setting (BT) in the Installer
Menu to a number 1 (Extended). Follow the
steps in the menu tree shown on the next
page.
Make sure both the left and right 8Ah DC
battery wires are disconnected. Never
mix battery sizes, types, or brands.
Wallace Perimeter Security strongly
recommends that only sealed AGM
style batteries be used. If you plan to
remove the batteries from the operator,
properly store or discard them. Refer
to “Hazardous Materials and Proper
Disposal” on page 24 .