Wallace Perimeter Security ALPHA, Руководство по установке и обслуживанию

Страница: 88 / 182

88
wallaceperimetersecurity.com
Phone: 866.300.1110
VIEWING OPERATOR STATUS DISPLAYS
Viewing Operator Status Displays
Press the MENU button once and the operator status displays appear in two second intervals. Pertinent
information appears to provide a quick overview of the operator’s status or configurations. Refer to
Figure 27 below.
Variables
The software version and revision
number are hard-coded in the
SmartDC Controller.
PRIMARY or SECONDARY
(This display only appears when the
operator is used in bi-parting gate
systems.)
OT 15 = Kinetic DC15W [Kinetic 1] at
1ft/s;
OT 16 = Kinetic DC10FW [Kinetic 2]
at 2ft/s
LEFT or RIGHT
1, 2, 3, or 4
Note: OT 16 only accepts Usage Class
3 and 4.
0 = 8Ah (standard factory issue)
1 = 50Ah (optional upgrade)
2 = 110Ah (option)
Number varies depending on the
voltage that the charger is providing.
One cycle equals a full open and
close sequence. Partial cycles are not
counted.
The first menu item in the User
Menu. See
“USER MENU” on page
89 .
Description
This display appears only when you press RESET
or cycle the power. It displays the software version
which is useful as a maintenance tool.
Indicates, in a dual gate setting, whether the
operator is set to Primary or Secondary. The setting
is assigned in the Installer Menu.
Indicates and identifies the operator and charger
type.
Designates which way a gate opens viewed from
the operator. If it slides to the left, it is a left-hand
gate. Gate handing is established in the initial
Setup Menu.
Displays the operator’s Usage Class designation
per UL 325 standards. Refer to “Identifying Gate
Operator Category and Usage Class” on page
27 .
Confirms the operator’s battery type. If you use
the larger capacity batteries you must configure
the operator through the Installer Menu. See
“BATTERY TYPE” on page 108 .
Displays the actual charging voltage.
Displays the number of cycles the gate operator
has incurred. Similar to an odometer, it resets to
zero after 999,999 cycles.
Note: You can also access the Installer Menu from
this display. See “Installer Menu” on page 98 .
Displays the number of seconds before the open
gate initiates.
Figure 27. Operator Status Displays