Wallace Perimeter Security ALPHA, Руководство по установке и обслуживанию

Страница: 112 / 182

112
wallaceperimetersecurity.com
Phone: 866.300.1110
INSTALLER MENU FUNCTIONS
Table 6. SmartDC Controller - Installer Menu Functions
Ref.
No�
Installer Menu Setting Options
(
Bold
= Factory Settings)
Menu Tasks and Explanations
Associated
DC Controller
Connections
Display
32
IR 1 REVERSE
INSIDE OBS LOOP
0 = Pause closing only
1 = Enable reversing to
open
The default is for full reversal when the
Inside Obstruction Loop is triggered. A
setting of 0 causes the gate to only pause
when triggered. Closure begins as soon as
the loop is clear again.
INSIDE OBS
LOOP
COM or HY5A/
HY5B/HY5B
2.0
33
DL 1 STANDARD
DETECTOR LOGIC
1 = Standard
2 = Quick closed
3 = Forced Time out
4 = Full anti-tailgate
Configures for faster closure. This
selection determines whether the close
timer begins to count after vehicles have
departed the detector loops or whether
the close timer will count down while the
loops are occupied. The gate can only
close when all loop detectors are not
triggered.
Refer to “Vehicle Detector Configuration
and Quick Close Mode Selection” on page
126 .
HY5A/HY5B/
HY5B 2.0
34
RL 1 0 DISABLED
RELAY 1 LOGIC
0 = Default
1 to 45 available
Configures the function of the user 1
output relay, which is a large mechanical
relay. It has the capacity to switch both AC
and DC and can be used for high voltage
and/or high current loads. Connect
devices directly to the top of the relay:
COM plus NO and NC contacts.
Forty-five optional logic functions exist.
See “Setting the User Relay Function in
the Installer Menu” on page 141 .
User 1 Relay
35
RL 2 1 CLOSE LIMIT
RELAY 2 LOGIC
0 = default
1 to 45 available
Configures the function of the user 2
output relay, which is an electronic relay
with the capacity for switching a DC load
only. The User 2 Relay is limited to 48 Volts
DC and 4 amps maximum load. Connect a
device directly to the two spade terminals
at the bottom of the control board, next to
the label USER 2.
Forty-five optional relay functions exist.
See “Setting the User Relay Function in
the Installer Menu” on page 141 .
User 2 Relay