Wallace Perimeter Security ALPHA, Руководство по установке и обслуживанию

Страница: 113 / 182

Alpha/Delta (Kinetic Operator) Installation and Maintenance Manual Revision 1 - MAY 2023
113
INSTALLER MENU FUNCTIONS
Table 6. SmartDC Controller - Installer Menu Functions
Ref.
No�
Installer Menu Setting Options
(
Bold
= Factory Settings)
Menu Tasks and Explanations
Associated
DC Controller
Connections
Display
36
RL 3-10 0 CLOSE LIMIT
RELAY 3-10 LOGIC
0 = Disabled
Up to 45 available
Similar to Relay 1 logic.
Note: The Hy8Relay™ module option can
be purchased for eight additional NO relay
outputs. Relay #39 set aside for Factory
Use. Use addresses 1-4 when connecting
to HyNet.
User 3 - 10
Relay
37
TL 2 (45 SECS)
OPEN TIME ALERT
0 = 0 seconds
1 = 15 seconds
2 = 45 seconds
3 = 75 seconds
4 = 105 seconds
5 = 135 seconds
Adjusts the time delay before activating
a user relay. Maximum time setting is
135 seconds. See “Setting the User Relay
Function in the Installer Menu” on page
141 .
Note: This menu appears only when a
user relay is set to Function No. 8.
User relays
38
LT 2 (45 SECS)
LOITERING ALERT
0 = 0 seconds
1 = 15 seconds
2 = 45 seconds
3 = 75 seconds
4 = 105 seconds
5 = 135 seconds
This function monitors activation of the
Outside Obstruction Loop when there
is no activation of the gate. When the
adjustable period of time is exceeded,
User Relay No. 13 triggers and reports
loitering in the diagnostics log.
Adjust the time delay before activating
the user relay. Maximum time setting is
135 seconds. See
“Setting the User Relay
Function in the Installer Menu” on page
141 .
Note: This menu appears only when a
user relay is set to Function No. 13.
User relays
39
SA 0 (OFF)
SDC ADDRESS
0 = No network
1 to 99 = Network “drop”
address
Sets the system address for network
communication:
0 = no network communication.
1-99 sets individual polling addresses. Use
addresses 1-4 when connecting to HyNet.
RS-485
40
ELD 0 (RUN MODE)
EXIT LOOP SET
0 = Run mode
1 = Show frequency
2 = Show call level 0-7
3 = Set Frequency
Controls the HY5A/HY5B/HY5B 2.0 Free
Exit detector. If an HY5B is used, additional
settings of 4-8 are available:
4 = Show Sensitivity
5 = Set Sensitivity
6 = Show Inductance
7 = Show Loop Health
8 = Set Presence
HY5A/HY5B/
HY5B 2.0