Wallace Perimeter Security ALPHA, Руководство по установке и обслуживанию

Страница: 126 / 182

126
wallaceperimetersecurity.com
Phone: 866.300.1110
VEHICLE DETECTOR CONFIGURATION AND QUICK CLOSE MODE SELECTION
Vehicle Detector Configuration and Quick Close Mode Selection
The Standard Quick Close modes are selectable in the Installer Menu. Refer to “Table 6. SmartDC
Controller - Installer Menu Functions” on page 106 . The four selectable modes are described as follows:
Mode 1 (Default)
An input from either the Free Exit, Outside Obstruction Loop, Inside Obstruction Loop or the Center Loop
will hold the gate open, reset the close timer, and block all close inputs. (Center Loop has no gate control
function in a slide gate. However, the input may be used as an arming loop when used in conjunction with
Relay function #22.)
Mode 2:
Same function as Mode 1, except the close timer can count to zero even with the Free Exit, Outside
Obstruction Loop, Inside Obstruction Loop or the Center Loop detector inputs active. If the close timer
has counted to zero, the gate will close when all detector inputs are clear. (Center Loop has no gate control
function in a slide gate. However, the input may be used as an arming loop when used in conjunction with
Relay function #22.)
Mode 3:
Same function as Mode 1. However, the close timer is forced to zero when both the OOLD & IOLD are
tripped simultaneously. Additionally, all other close inputs are memorized and the gate closes immediately
when all open commands and vehicle detector inputs are clear.
Mode 4:
Full anti-tailgate logic includes Mode 3 functions. In addition, the gate will stop during the opening cycle
when both OOLD & IOLD are tripped simultaneously. When the OOLD & IOLD loops are cleared, the gate
closes immediately. The OOLD & IOLD can be individually set so that, if tripped while closing, the gate may
pause only or reverse to reopen. The free exit detector input is blocked while the gate is closing.
NOTE:
As described in
“Table 9. User-Programmable User Relays - Function Options” on page 129
, the
OOLD and IOLD loops must be capable of being triggered at the same time for the Unauthorized Vehicle
Entry Output relay (#11) to ever activate.