Teseq NSG 3040, Руководство пользователя

Страница: 43 / 156

43
on the front panel. When the button is set to “CONT.”, the test will continue
even if the EUT fail.
EUT Power Supply at EUT Fail Input
Touch the “EUT Power Supply at EUT Fail Input” button (not shown on example)
to specify the action taken if an “EUT fail signal” is generated.
When the button is set to “On”, EUT power stays ON after the “EUT fail Input”
is activated.
When the button is set to “Off”, EUT power shuts down when the “EUT fail
Input” is activated.
EXIT
Touch the “Exit” button to return to the system window without saving changes.
EUT ON/OFF
This button displays the EUT input power status.
OK
Touch the ”Ok” button to save changes and return to the system window.
7.3 Updating SUI software via the SD-card
To change the SUI software, first switch off the generator and remove all power
cords and cables. Open the top housing cover of the generator as described
below.
WARNING - Before opening the generator make sure
that it is turned OFF and disconnected from all power
and signal cables!