Technogym BIOSTRENGTH LINE, Руководство по техническому обслуживанию

Страница: 380 / 646

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 7.206
7.5.34. D
ISASSEMBLING THE CROSS AND WEIGHT STACK PLATES
Figure 7.5.34-1
Follow the steps described in paragraph 7.5.30.
“Disassembling the columns” limited solely to
the right-hand column.
1. Select the minimum weight (5 Kg or 10 lbs.).
For each bar:
2. Loosen the dowel
a using a 4-gauge
hexagonal T-wrench.
3. Remove the counter-weight.
4. Disconnect the solenoid cable connector.
5. Unhook the encoder cable.
Figure 7.5.34-2
6. Raise the CROSS until the cross sinker is
released from the WEIGHT STACK
PLATES, and lock in this position.
Follow the steps described in paragraph 7.5.33.
“Disassembling the bars”.
7. Remove the CROSS and WEIGHT STACK
PLATES by sliding them out from the side.
Make sure the stack of PLATES does
not tip over.
To reassemble the CROSS and WEIGHT
STACK PLATES, follow the above steps in
reverse order.