Technogym BIOSTRENGTH LINE, Руководство по техническому обслуживанию

Страница: 200 / 646

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 7.26
7.1.24. D
ISASSEMBLING THE ELECTRONIC COMPONENTS OF THE ELECTRICAL BOX
Figure 7.1.24-1
Follow the steps described in paragraph 7.1.23.
“Disassembling the electrical box”.
With the electrical box resting on a bench:
To disassemble the POWER SUPPLY
a :
1. Disconnect the 2 connectors.
2. Disconnect the 4 plastic coupling elements.
3. Remove the card.
To disassemble the FPGA BOARD
b :
1. Disconnect the 4 connectors.
2. Disconnect the 4 plastic coupling elements.
3. Remove the card.
To disassemble the IMP BOARD
c :
1. Lift the board.
2. Disconnect the 2 connectors.
3. Disconnect the 4 plastic coupling elements.
4. Remove the card.
To disassemble the IEM BOARD
d :
1. Lift the board.
2. Disconnect the 2 connectors.
3. Disconnect the 4 plastic coupling elements.
4. Remove the card.
To disassemble the TRANSFORMER
e :
1. Disconnect the secondary cables from the
board connectors.
2. Unweld the primary cables from the selector
switch.
3. Unscrew the holding screw a using an 8-
gauge wrench.
4. Remove the transformer.
Continued on next page
→