Technogym BIOSTRENGTH LINE, Руководство по техническому обслуживанию

Страница: 615 / 646

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 9.7
9.2.10. S
EAT MOTOR INERTIA
This parameter does not appear for Abdominal Crunch and Lower Back.
This option allows you to set the inertia of the motor and of the mechanical seat selection system,
expressed in pulses produced by the encoder associated with the seat motor, so that the seat may be
stopped in the desired position:
O F F S E T M O T O R S E A T O F F
P U L S E S = X
Physically, this parameter is the motor stop advance.
This value depends on the type of motor used and the mechanics used to make the
selection. This value is factory-set as indicated in the table below:
Machine Pulses
Leg Extension 2
Leg Curl 2
Vertical Traction 2
Shoulder Press 2
Chest Press 2
Rowing Torso 2
Leg Press 20
It may be necessary to change it due to changes in the selection system conditions.
Should you observe that the relays of the seat motor interface board sputter when
stopping the motor, after jumps caused by constant adjustments to the motor position,
then you must increase the value of this parameter. Indeed, if the motor inertia is
greater than the configured parameter, when stopping the motor goes beyond the
position to be reached; the control drives it back and forth several times until it is locked
in the correct position, causing the relays to sputter.
Enter the value, then press “Enter” to continue or “Clear” to abort.
9.2.11. M
INIMUM
ROM
LENGTH
This option allows you to set the value in cm of the parameter “ROM minimum length”; for a
description of this parameter, see paragraph 11.1. “Configuration parameters for exercise ROM
acquisition”:
R O M M I N I M U M L E N G T H
c m = X X
These distances are factory-set as indicated in the table below: