Technogym BIOSTRENGTH LINE, Руководство по техническому обслуживанию

Страница: 622 / 646

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 9.14
9.3.9. P
ACER SPEED
This option allows you to set the speed of the pacer, if present:
P A C E R S P E E D 3 0 - 8 0 0
m m / s e c = X X X
You may enter any value between 30 and 800 mm/sec. These speeds are factory-set to their
recommended default value, as indicated in the table below:
Machine Speed
Abdominal Crunch 50
Lower Back 100
Leg Extension 300
Leg Curl 250
Vertical Traction 210
Shoulder Press 210
Chest Press 470
Rowing Torso 300
Leg Press 220
Enter the desired value, then press “Enter” to continue or “Clear” to abort.
9.3.10. T
IME BEFORE LOAD
This option allows you to set the timeout in seconds the machine waits, when the weight stack is in
stand by position, before considering that the set is over.
T I M E B E F O R E L O A D :
1 - 3 0 S E C . = X X X
You may enter any value between 1 and 30 sec. This time is factory-set to 5 sec.
9.3.11. P
ERFORM AUTO
-
CONFIGURATION PROCEDURE
This option allows you to set whether to perform the automatic procedure to configure the machine's
ROM parameters: default ROM length, default ROM start, %ROM first repetition and ROM
minimum length (for a description of their meaning, see paragraph 11.1. “Configuration parameters
for exercise ROM acquisition”). The automatic configuration is set up so that the value of the 4
parameters listed above is deduced from performing 3 repetitions:
A U T O C O N F I G .
N = 1 Y = 2 = X
The following options are available:
•
NO = 1;
•
YES = 2.