Sun Microsystems Netra CT 410, Руководство по обслуживанию

Страница: 94 / 296

5-6 Netra CT Server Service Manual • February 2007
For a Netra CT 410 server, output similar to the following is displayed:
The attachment-point ID is shown in the first column of the readout; for example,
the attachment-point ID for I/O slot 2 in a Netra CT 810 server is
IO-2.
To view the online help for
cfgadm
, as superuser, enter:
Output similar to the following is displayed:
To view the man page for the
cfgadm
utility, enter
man cfgadm
at the prompt.
5.2.3 Basic and Full Hot-Swap
cfgadm
Commands
The Netra CT servers are set to full hot-swap by default. Full hot-swap on an I/O
slot means that you do not need to manually deactivate or activate the I/O board
when replacing it in the server; those processes are handled automatically.
■
To determine the current hot-swap state for all of the I/O slots in your Netra CT
server, go to
“Determining the Current Hot-Swap State” on page 7 .
■
To change default settings for one or more I/O slots in your Netra CT server to
basic hot-swap, go to
“Enabling Basic Hot-Swap on I/O Slots” on page 8 .
■
To change settings for one or more I/O slots in your Netra CT server back to full
hot-swap, go to
“Enabling Full Hot-Swap on I/O Slots” on page 9 .
Ap_Id Type Receptacle Occupant Condition
AL-1 mcd/fhs connected configured ok
CPU bridge/fhs connected configured ok
IO-2 unknown disconnected unconfigured unknown
IO-4 stpcipci/fhs connected configured ok
IO-5 stpcipci/fhs connected configured ok
# cfgadm -h pci
PCI hotplug specific commands:
-c [connect|disconnect|configure|unconfigure|insert|remove] ap_id [ap_id...]
-x enable_slot ap_id [ap_id...]
-x disable_slot ap_id [ap_id...]
-x enable_autoconfig ap_id [ap_id...]
-x disable_autoconfig ap_id [ap_id...]
-x led[=[fault|power|active|attn],mode=[on|off|blink]] ap_id [ap_id...]