Sun Microsystems Netra CT 410, Руководство по обслуживанию

Страница: 153 / 296

Chapter 7 Removing and Replacing Hard Drives and Removeable Media 7-15
■
If you installed a DAT drive in your server, output similar to the following is
displayed:
Locate the line with the attachment point
c0::rmt/0
listed in the
Ap_Id
column. Verify that the following entries appear for the DAT drive that you
just installed:
■
If you see
tape
in the Type column and
configured
in the Occupant column,
then the DAT drive is activate. Skip to Step 8 .
■
If you see unavailable instead of
tape
in the Type column and unconfigured
instead of
configured
in the Occupant column, then the DAT drive is not
activate. Enter the following command to activate the DAT drive:
Enter the
cfgadm -a c0
command a second time to verify that the DAT drive is
activate.
Also, you can use the removable media module (RMM) LEDs on the system
status panel to verify that the removable media drive is activate. When the Okay
to Remove LED (
) on the system status panel for the removable media drive
is OFF, the removable media drive is activate.
8. Start the Volume Manager daemon.
As superuser, enter:
Ap_Id Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/c0t0d0 disk connected configured unknown
c0::dsk/c0t6d0 unavailable connected unconfigured unknown
c0::rmt/0 tape connected configured unknown
c0::rmt/0 tape connected configured unknown
# cfgadm -c configure c0::rmt/0
# /etc/init.d/volmgt start