Sun Microsystems Netra CT 410, Руководство по обслуживанию

Страница: 160 / 296

8-6 Netra CT Server Service Manual • February 2007
3. Push the system status panel into place against the server, paying special attention
to the connector on the left side of the panel, making sure that the connector on
the left rear of the system status panel mates fully with the system controller
board.
Note –
Be careful not to press the power switch when you are pressing the left side
of the system status panel into place.
4. Using a No. 2 Phillips screwdriver, tighten the two captive screws to secure the
system status panel to the system.
FIGURE 8-2
shows the location of the captive screws on the Netra CT 810 server, and
FIGURE 8-3
shows the location of the captive screws on the Netra CT 410 server.
8.2 System Controller Board
This section describes how to remove and replace a system controller board. Each
server has a single system controller board.
Note – You must have the alarm card and host CPU board installed in the server
before you can hot-swap the system controller board.
8.2.1 Removing the System Controller Board
1. Go to the front of the system and use the system status panel to determine if the
system controller board failed.
FIGURE 8-6
shows the locations of the system controller board LEDs on the Netra CT
810 server, and
FIGURE 8-7
shows the locations of the system controller board LEDs
on the Netra CT 410 server.