Sun Microsystems Netra CT 410, Руководство по обслуживанию

Страница: 122 / 296

6-24 Netra CT Server Service Manual • February 2007
6.2 Rear Transition Modules
Note –
The rear-transition modules are only hot-swappable as long as the
accompanying host or satellite board is removed first .
The following rear transition modules extend the ports from the host and satellite
boards to the rear:
■
Host rear transition modules
■
Satellite rear transition modules
■
Alarm rear transition modules
■
I/O rear transition modules
This section contains procedures for the installation, removal, and replacement of
the following hot-swappable modules for the Netra CT 410 server and Netra CT 810
server:
■
Section 6.2.1, “Host Rear Transition Modules” on page 6-24
■
Section 6.2.2, “Satellite and I/O Rear Transition Modules” on page 6-30
■
Section 6.2.3, “Alarm Rear Transition Module” on page 6-35
6.2.1 Host Rear Transition Modules
This section explains how to remove and replace host rear transition modules.
The following are the possible pairings of host boards with rear transition modules:
■
Netra CP2140 host board and Netra CT CPU transition card. With the Netra
CP2140, use
only the Netra CT CPU transition card (CTC, hereafter referred to as
rear transition module) in the Netra CT server; do not use the XCP2040-TRN I/O
transition module that is available with the Netra CP2140 board. See
FIGURE 6-16
to determine if the module you have is supported or unsupported on a Netra CT
server.
■
Netra CP2500 host board and Netra CP2500 RTM-H (rear transition module-host).