Sun Microsystems Netra CT 410, Руководство по обслуживанию

Страница: 133 / 296

Chapter 6 Removing and Replacing Hot-Swappable Boards 6-35
9. Plug all appropriate cables into the rear transition module.
Tighten the screws on the cable to a torque of 0.23 N.m (2 in.-lb). Refer to the
documentation that you received with the board.
10. Go to the front of the server, and install the satellite CPU or I/O board in the
Netra CT server.
See Section 6.1.2.2, “Inserting a Board” on page 6-15 for instructions.
6.2.3 Alarm Rear Transition Module
The alarm rear transition module for the Netra CT 810 server consists of two
separate components:
■
The alarm card
■
The alarm rear transition module
When one of the two components fails, you might not be able to determine which of
the components failed. Because of this, you might want to replace both the alarm
card
and the alarm rear transition module.
The alarm card is installed in the front of the Netra CT server.
The alarm rear transition module extends the ports on the alarm card to the rear of
the system. The alarm card must be installed in the front of the server for the alarm
rear transition module to work.
■
If you are removing and replacing faulty components in the server, first go to
Section 6.2.3.1, “Removing an Alarm Rear Transition Module” on page 6-36 , then
go to Section 6.2.3.2, “Installing an Alarm Rear Transition Module” on page 6-38 .
■
If you are installing new components in a server, go to Section 6.2.3.2, “Installing
an Alarm Rear Transition Module” on page 6-38 .