Sun Microsystems Netra CT 410, Руководство по обслуживанию

Страница: 125 / 296

Chapter 6 Removing and Replacing Hot-Swappable Boards 6-27
■
If you are removing and replacing a faulty module in the server, first go to
Section 6.2.1.1, “Removing a Host Rear Transition Module” on page 6-27 , then go
to “Installing a Host Rear Transition Module” on page 28 .
■
If you are installing a new module in the server, go to Section 6.2.1.2, “Installing a
Host Rear Transition Module” on page 6-28 .
6.2.1.1 Removing a Host Rear Transition Module
1. Attach the antistatic wrist strap.
See Section 1.2, “Attaching the Antistatic Wrist Strap” on page 1-2 .
2. Go to the front of the system and remove the host CPU board, if you have not
done so already.
See Section 6.1.2.1, “Removing a Board” on page 6-9 to remove the host CPU board.
3. Go to the rear of the system and locate the host rear transition module.
FIGURE 6-18
shows the location of the host rear transition module on the Netra CT
810 server, and
FIGURE 6-19
shows the location of the host CPU rear transition
module on the Netra CT 410 server.
FIGURE 6-18
Locating the Host Rear Transition Module in a Netra CT 810 Server
(Top View)
Midplane
Front of
chassis
Rear of
chassis
Slot 8
Slot 4
Slot 5
Slot 6
Slot 7
Slot 2
Slot 3
Slot 1
Slot 8
Slot 4
Slot 5
Slot 6
Slot 7
Slot 2
Slot 3
Slot 1
Single-wide 6U alarm card
Satellite or I/O board
Satellite or I/O board
Satellite or I/O board
Satellite or I/O board
Satellite or I/O board
Satellite or I/O board
Host CPU board
Hard drives
Alarm RTM
CPU or I/O RTM
CPU or I/O RTM
CPU or I/O RTM
CPU or I/O RTM
CPU or I/O RTM
CPU or I/O RTM
CTC or RTM