Sun Microsystems Netra CT 410, Руководство по обслуживанию

Страница: 146 / 296

7-8 Netra CT Server Service Manual • February 2007
14. Continue to pivot the disk drive bracket handle against the chassis, applying mild
pressure until the drive disconnects.
15. Slide the drive out of the chassis, and place it on an electrostatic discharge mat.
16. Secure the drive bay cover over the drive bays (
FIGURE 7-1
).
You must install the drive bay cover over the drive bays to ensure proper airflow in
the system.
7.1.2 Installing a Hard Drive
1. Attach the antistatic wrist strap.
See Section 1.2, “Attaching the Antistatic Wrist Strap” on page 1-2 .
2. Remove the drive bay cover (
FIGURE 7-2
).
3. Hold the bracket handle on the disk drive open.
4. Slide the replacement disk drive into the drive slot.
5. Gently push the drive until the locking handle engages.
6. Close the locking handle completely, using gentle downward pressure.
7. Replace the drive bay cover.
8. Log in to the server and, as superuser, activate the replacement hard drive:
where ap_id is the attachment-point ID for the hard drive that you just installed. For
example, to activate the upper hard drive (HDD 0), you would enter:
# cfgadm -c configure
ap_id
# cfgadm -c configure c0::dsk/c0t0d0